Perfection in dental prostheses: perfect fit, occlusion & compatibility.

The SR-Ivocap® injection technique offers patients and dentists decisive advantages over the packing/pressing technique.

For the patient, SR-Ivocap® provides sturdy dentures that fit, restoring proper suction with no bothersome pressure points or requiring numerous adjustments by the dentist.

For the dentist, there is no increase in vertical dimension - practically eliminating reocclusion and grinding. This saves time and results in greater certainty for successful prosthesis.

It is the Systematic Technique that assures efficient procedure and the consistently high quality of SR-Ivocap® prostheses.

The System...

The system begins with predosed resin in capsules. This assures clean, perfect composition - no possibility of contamination and error-free mixing dosage monomer and polymer.

Mixing of the pre-measured monomer and polymer is done in the patented Cap Vibrator - producing a fully homogenous mix of the materials.

Injection of the SR-Ivocap® denture material into the flask is done under 6 bar pressure and is maintained during subsequent polymerization.

Controlled heat/pressure polymerization... The Ivocap unit under pressure is then placed in boiling water. The design of the flask plus the thermal insulator, enables controlled polymerization from bottom to top. Polymerization shrinkage is constantly compensated for by the continuous pressure feeding of the SR-Ivocap® denture material.

Cooling... After polymerization, cooling off is done in a cold water bath. Injection and clamping pressure are retained. The SR-Ivocap® denture material is still fed into the flask even during this curing process - continuing to compensate for shrinkage.

SR-Ivocap® is universally applicable for:

• Full Dentures
• Partial Dentures
• Bases and Relining

SR-Ivocap® Elastomer, a material with special physical characteristics, is especially good for:

• Positioners
• Athletic Mouth guards
• Bruxism Splints
• Bite Splints requiring elasticity